![]() When evaluating Pelco Digital Sentry, the following 9 key criteria / decision points should be considered. Llimited advanced functionality (no enterprise user management, maps, etc.).With over a dozen tools installed, administration can be initially overwhelming.Support documentation is outdated and can cause confusion.Investigation workflow is fairly simple.DS Quick Setup Wizard is helpful for installers and administrators.Note that the DS4U edition only supports Pelco IP cameras (while the full Digital Sentry supports 3rd party IP cameras).Ĭompare to our test results of Axis Camera Station (for a single camera vendor solution) or Exacq (for a multi-camera vendor solution) that provides comparable features and functionality. You can test the software yourself (with the DS4U free edition ). The test was hosted on a Windows XP machine, connected to the IQinVision Series 4, Pelco Sarix IXE20DN and Sony SNC-CH140 cameras. In this test, we examine Pelco's Digital Sentry VMS software - ControlPoint client v. As they and other incumbents move to IP, these offerings will receive more attention. While the company is one of the largest global analog surveillance providers, this is primarily for its cameras and recorders. Dimensions - 50.8 x 43.4 x 8.9 cm (20" D x 17.1" W x 3.Pelco is not known for its software. ![]() Operating Vibration - 0.25 G at 3 Hz to 200 Hz at a rate of 0.5 octave/minute Maximum Humidity Gradient - 10% per hour.Operating Humidity - 20% to 80%, noncondensing.Hard Disk Status - Green, red, off (behind bezel).Software Status - Green, amber, red (based on diagnostics).Power Input - 100 to 240 VAC, 50/60 Hz, autoranging.Interface - Gigabit Ethernet (1000Base-T) ports (2x).Connector Ring - Signal right (input and output).Connector Tip - Signal left (input and output).Audio Connectors - 2, 3.5 mm stereo jacks.Output - Up to 3 Vp-p, adjustable, minimum load of 8 ohms.Supports up to 6 Optera IMM Series cameras. ![]()
0 Comments
Leave a Reply. |